Ender 3 LCD Right Angle & Relocation

To fit my Ender 3 into a cabinet, I needed to relocate the LCD/control panel to a new spot. In this case, I moved it from the front-right original location to the back-left corner, rotated at 90°.

This Thing includes 3 main components:
• Rear LCD cover panel
• LCD base
• Short frame extension / clip

The clip snaps into holes in the base, and fits into the extruded frame component / foot of the Ender 3. This entire set of components places the LCD screen as shown in the included images, and it SHOULD clear the rear cable for heating and grounding the bed, but make sure you double-check before running your machine since it's fairly close quarters there.

The LCD rear cover also includes a slot for an SD card reader. You'll need the 18" extension cable, as it's a fairly long reach. I ended up snaking mine through the stepper driver enclosure, but you could also carefully slip it underneath the printer.

If you skip the extension clip, you could even attach rubber feet and