Thingiverse
Ender 3 Light Bar
by Kevlarr
2k
Downloads
1.1k
Likes
19
Makes
Simple light bar to mount an LED strip to the top 20x20 extrusion. Included a small test print to check fitment in the extrusion..
Each bar is 150mm in length so print two to span the top of your printer.
I used silicone coated strip which stays in the channel without having to use any adhesive tape, un-coated LED strips may need to use double sided tape.
Print vertically and no supports are needed.
Each bar is 150mm in length so print two to span the top of your printer.
I used silicone coated strip which stays in the channel without having to use any adhesive tape, un-coated LED strips may need to use double sided tape.
Print vertically and no supports are needed.
Kevlarr also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!