Ender 3 max PSU relocation case and brackets V1

Ender 3 max rmeanwell psu relocation cage. Needed after fitting a dual z axis lead screw kit.

This was my first version and was somewhat over engineered. I later went over the design and did a new version that is less substantial but still more than strong enough. The 2 new revisions are here https://www.thingiverse.com/thing:5161606

Cage itself is a one piece print. Frame rail mounts are in two versions. the first and simplest just uses two side slots. the second uses 2 side slots and one top. There are end stop half support width versions for both these designs to allow the cage fitting to move further along the frame rail away from the gantry frame.

There is a large hole in the cage base to allow the power plug through. When fitting the mounts, If you are not using the cable tie option (that would also give correct alignment I designed it to) remember to keep this hole clear.

All the brackets are slotted and when aligned with the correct holes of the cage you can run ca