Ender 3 Power Switch

Ender 3 Power Switch

Relocate your Power Switch to the Front of your Machine

This is simply a power switch case that is bolted onto the front of an Ender 3 (in my case Ender 3 V2). The steps that I used to install are as follows:

+ NOTE: Make sure your printer is calibrated properly so the tolerances will work.

+ CAUTION: Please be careful! Please don't mess around with your power supply unless you have proper preparation or experience with electricity and how it works. I am not responsible for you frying yourself or frying your 3D printer if you do not do this properly. BE CAREFUL! BE SMART! BE PREPARED!


1. Print the parts I provided. About a 2-hour print time maximum. Allow cooldown.
2. Unplug the 3D printer ENTIRELY from any power source.
3. Disconnect power cables from the switch and Extend the power cables that connect to the power supply so that it reaches the front. I used about 12 inches of ~14 gauge wire and it works perfectly. Also, Mark the ends so you kno