Thingiverse
Ender 3 Pro Cable Guard
von Pro3DMaker
4
Downloads
2
Likes
0
Makes
I designed this guard to fit into the cut out where the wires feed from the main board to the back of the machine.
Print at 100%.
If your bed is not level or if you usually have elephant's foot, print on a raft.
Print at 100%.
If your bed is not level or if you usually have elephant's foot, print on a raft.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
