ender 3 pro lack enclosure

I liked the idea of the enclosure for my ender 3 pro. i printed some leg extensions off of someone else on here and added them to my enclosure but didn't like how the stand wobbled.( kids who like to touch things they shouldn't) the material of the tables are so thin that screws pull out relatively easy. so i designed these. The are about .04mm larger than the actual table to get a good fitment, 105mm long, and have a recess in the sides to put a small steel washer so that i can glue small neo magnets to the plexis glass sides for easy removal. the material was proto pasta HTPLA. 50% infill, can probably go lower because when printed at higher temp the layer adhesion and strength is actual very good. it does require supports due to the bottom tabs. and a thicker raft to prevent the sides from warpage. If any one sees anything that might make this better let me know.