Thingiverse
Ender 3 Pro Lower Cable Guide
door DPS_Design
4
Downloads
1
Likes
0
Makes
After mounting all my Ender's electronics remotely, the cable pass-thru is too good to pass up for my Pi camera cable - but not with those sharp edges.
I beveled all edges the cable will touch, so cables slide very easily. -My camera cable slides through with the bed moving on the Y axis.
I beveled all edges the cable will touch, so cables slide very easily. -My camera cable slides through with the bed moving on the Y axis.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
