Thingiverse
Ender 3 Pro Power Relocation
di Smyffe
8
Download
9
Likes
0
Makes
This is a relocation of the power unit for a ender 3 pro purchased after or around July 2021
i have also added a cable chain mount that suits Johnniewiskey's chains https://www.thingiverse.com/thing:2920060
Uses original screws from power box, NO extra screws needed,
overtime i will be updating this, any suggestions feel free to leave a comment.
i am planning on making a rear exit and right side exit cable versions too
---------------------------------------------------------------------------------------------------------------------
Print Temp: 185
Bed Temp: 55
Supports: Tree Supports @10degrees supporting anything over 70degrees
Slicer: Cura
I recommend printing these with the smallest flat surface on the bed
i have also added a cable chain mount that suits Johnniewiskey's chains https://www.thingiverse.com/thing:2920060
Uses original screws from power box, NO extra screws needed,
overtime i will be updating this, any suggestions feel free to leave a comment.
i am planning on making a rear exit and right side exit cable versions too
---------------------------------------------------------------------------------------------------------------------
Print Temp: 185
Bed Temp: 55
Supports: Tree Supports @10degrees supporting anything over 70degrees
Slicer: Cura
I recommend printing these with the smallest flat surface on the bed
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
