Thingiverse
Ender 3 Pro Raspberry Pi Camera Bed Mount
von Sparkoflight
10
Downloads
3
Likes
0
Makes
Raspberry Pi Camera mount, case and camera arm extension remixed to fit my Ender 3 Pro. The Petsfang Blokhead currently in place on my PETG printer kept bumping the camera while bed levelling, so I put together a camera arm extension to prevent this from happening.
I have also included an extended bed mount if you want to keep the camera height of the original.
No support required.
Drop the MK2 Camera Extender just below the build plate until the base of the rectangle section is touching.
Please note, the BlokHead cooling system is not currently used on this printer and has been moved up to it's highest point off the bed.
I have also included an extended bed mount if you want to keep the camera height of the original.
No support required.
Drop the MK2 Camera Extender just below the build plate until the base of the rectangle section is touching.
Please note, the BlokHead cooling system is not currently used on this printer and has been moved up to it's highest point off the bed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
