Ender 3 Pro spring based damper foot

These are spring based vibration damper feet for the Ender 3 Pro (I think, that they should be compatible to the Ender 3, as well).

The larger case part is the lower part in which you have to place 2 springs. Into that lower part you have to place the top part onto which you can then place the rubber foot of the Ender 3 Pro. The installation of all four feet is quite challenging, but it can be done.
You might want to install additional rubber feet below those dampers. My Ender 3 Pro sits on an anti slip mat, so for me this was not neccessary.

You need to print both parts four times and you will need 8 springs with the correct dimensions and strenght. The ones I used are called Squik SC-18-026 / EAN: 0682604575667 / UPC: 682604575667 and you should be able to find them on Amazon (I added an image with dimensions of the springs which I found on Amazon).

Intentionally I made the lower (outer) part a little bit wider, so that there is a small gap between the upper (inner) and the