Thingiverse
Ender 3 Pro Tool Holder - Remix
by neyth_makes
32
Downloads
14
Likes
0
Makes
Remix of calaverajoe's toolholder. This version now securely slides into the rails instead of resting on top. There are gaps for the screws to go into, you just remove the screws, slide it in, then replace the screws. I also changed the positioning of the tools to allow easier access and included a slot for the SD to USB converter. Finally, I increased the size of the hole for the largest hex key as mine wouldn't fit.
This is a quick print (about 3 hours) that doesn't use much filament and is able to hold all the tools that came with my ender 3 pro.
I printed upside down, with supports everywhere at 40% infill and 0.2mm resolution.
Check out my insta for more projects: @neyth_makes https://instagram.com/neyth_makes
This is a quick print (about 3 hours) that doesn't use much filament and is able to hold all the tools that came with my ender 3 pro.
I printed upside down, with supports everywhere at 40% infill and 0.2mm resolution.
Check out my insta for more projects: @neyth_makes https://instagram.com/neyth_makes
neyth_makes also publishes on
39 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
