Ender 3/pro/v2 Riser feet 45mm

I basically re-modeled the original riser feet because it didn't fit my printer perfectly and I wanted to be able to fine tune it.

As the original creator instructed:
- You should print it sideways, so that rails are vertical and print well.
- No support needed, the overhang should print well.
- Rip off the original rubber pad carefully.
- Don't clean the glue off of the rubber feet so it sticks even better.
- You might need to remove larger glue residue from the printer, but don't clean it perfectly. You want to keep some friction.
- Use a small rocking motion to slide the rail in. It should slide into the extrusion profiles smoothly, without much force.

Feel free to remix this design, the STEP file is available in the downloads.

Fits well with the following mods:

Motherboard cover:
https://www.thingiverse.com/thing:4653994

Ender 3 v2 PSU cover + cables cover (80mm fan):
https://www.thingiverse.com/thing:5778820

Ender 3 v2 Front Power Switch Mod:
https://www