Ender 3 Pro / v2 Z support

Všetko čo som tlačil, nesplnilo požiadavky, a zároveň znižovalo max. výšku tlače 250mm na menej...
Navrhol som vlastné cez tinkercad.com...
Tento Z support sa da zasunúť pekne z boku bez rozoberania a potom vložiť ložisko...
Vzdialenosť od vonkajšej hrany skrutky je 25mm a stred ložiska teda 21mm.
Pred montážou som ešte nastavoval Z motor aby to išlo presne ako má...
Použite ložisko 608Z 22mm / 8mm


EN Translate by google

Everything I pushed did not meet the requirements, and at the same time reduced the max. print height 250mm for less ...
I designed my own through tinkercad.com ...
This Z support can be inserted nicely from the side without disassembly and then insert the bearing ...
The distance from the outer edge of the screw is 25mm and the center of the bearing is 21mm.
Before the assembly, I still adjusted the Z engine so that it went exactly as it should ...
Use bearing 608Z 22mm / 8mm