Thingiverse
Ender 3 Raspberry Pi 4
von Nateairman
14
Downloads
9
Likes
0
Makes
This is a mix of many parts and redesigned to house a Raspberry Pi4 on an Ender 3 pro chassis. A camera slot is in the case as well as a slot for the pin bus. the sd card slot was enlarged slightly.
I printed it using a Ditto Pro.
Settings are fixed in Tinkerine software I believe similar settings in cura slicer for the ender 3 would be:
PLA material
temp: 220c
bed: 50c
70mms
no support
18% fill
standard quality .2
Please comment.
I printed it using a Ditto Pro.
Settings are fixed in Tinkerine software I believe similar settings in cura slicer for the ender 3 would be:
PLA material
temp: 220c
bed: 50c
70mms
no support
18% fill
standard quality .2
Please comment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
