Thingiverse
Ender 3 Retraction Test
door klaymore
32
Downloads
15
Likes
0
Makes
This is a retraction test measuring 31x6x52. The base is 2mm thick. No skirt, just the starter line that runs fore to aft from Cura. In 10mm increments from the base of the pole, starts at a retraction of 1mm, 2,4,6,7; all at 25 mm/s. Coasting is on with a .04 volume @ 90% speed. No combing or wiping. Printed at 50mm/s, travel at 150mm/s. Retraction at layer change unchecked.
Printed on a 3mm mirror purchased and cut at Lowes. 55* bed, 210 nozzle.
Annotated in GCode where I changed retraction distances
Printed on a 3mm mirror purchased and cut at Lowes. 55* bed, 210 nozzle.
Annotated in GCode where I changed retraction distances
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
