Thingiverse
Ender 3 S1 Pro Tray - Split Version
von vmarchesin
2
Downloads
2
Likes
0
Makes
This is a remix with the parts split for better printing.
No supports required, unless you want to print everything together.
There are 4 files, one for each section and one for the whole thing. I recommend printing them separately to avoid supports or overhangs and later you can just snap them together. They fit perfectly inside the drawer and don't require glue, which is better in case you want to swap them later on.
If you don't want the nozzle tray just print the flat version, also available in the files.
No supports required, unless you want to print everything together.
There are 4 files, one for each section and one for the whole thing. I recommend printing them separately to avoid supports or overhangs and later you can just snap them together. They fit perfectly inside the drawer and don't require glue, which is better in case you want to swap them later on.
If you don't want the nozzle tray just print the flat version, also available in the files.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
