Ender 3 Screen Mount Stampede

This remix was to handle the exposed metal frame that the original didn't cover since you end up exposing the frame when relocating the screen. This mount was needed because of an issue where the screen was being grounded improperly against the Ender3 frame causing the screen to display crazy artifacting of letters/symbols/numbers so i had to move it off of the metal frame. you'll most likely have to use some type of power tool to be able to tap the stock screws into this print (I used a pen sized auto screwdriver to get the tap started and then an allen wrench was able to finish the rest. careful not to tighten too much as you'll strip it, it's plastic after all) but if you switched out the stock screws with some wider drywall/wood screws then tapping can easily be done by hand. it's the machine screws that make it hard to tap at the start. Use 3 walls on this and tapping the screw should work just fine. i did this with 10% infill.