Ender 3 Screw Stabilizer Higher

Screw stabilizer with skateboard bearing. Made to have less height restriction, only a few mm's of height restriction when installed.

.2 layer height and 100% infill works the best. No need for support.

Requires 1 skateboard bearing and 2 M5 screws with t-nuts (I used extra's that came with Ender 3).

I realized some screw stabilizers greatly restrict the print height, this one is pretty much as high as you can go with the design only restricting maximum height by a few millimeters. Use some heat while pressing in the bearing makes it allot easier.

Made to fit with the Ultimate Top Filament Roller.