Thingiverse
Ender 3 SD Card Holder (With Push Button)
9
Downloads
6
Likes
0
Makes
I printed the original one not realising that the printer wouldn't detect when I would swap SD cards so I would need to power down the printer then power back up to be able to read the new SD card.
I designed a push button to ''remove TF'' then ''insert TF'' so that I don't need to restart my printer every time.
I heard with a custom firmware the new SD would be detected but I can't compile a firmware and don't want to mess up my printer.
if you are in the same situation as me... enjoy !
Also, ignore the commentary in the video, I was sending it to my friend.
https://youtu.be/fpISAdPqr0A
I designed a push button to ''remove TF'' then ''insert TF'' so that I don't need to restart my printer every time.
I heard with a custom firmware the new SD would be detected but I can't compile a firmware and don't want to mess up my printer.
if you are in the same situation as me... enjoy !
Also, ignore the commentary in the video, I was sending it to my friend.
https://youtu.be/fpISAdPqr0A
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
