Thingiverse
Ender-3 SKR Case
von NettechSC
18
Downloads
7
Likes
0
Makes
This is my take on a case to house the SKR 1.4T main board for my Ender-3.
There are two versions of the lid, One with logos and one without.
Printed with PLA at 0.2mm layer height.
Use the existing screws to mount the case to the printer.
I used M3x5 screws to mount the board to the case.
For the fan, it is the stock 4010 case fan and 2 M3x15 screws with nuts. Although one should be enough.
The lid uses 2 M3x5 for the front and one M3x15 for the rear screw.
There are two versions of the lid, One with logos and one without.
Printed with PLA at 0.2mm layer height.
Use the existing screws to mount the case to the printer.
I used M3x5 screws to mount the board to the case.
For the fan, it is the stock 4010 case fan and 2 M3x15 screws with nuts. Although one should be enough.
The lid uses 2 M3x5 for the front and one M3x15 for the rear screw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
