Ender 3 Small spool holder

WARNING: Before you print, check to see if your version of original spool holder is the threaded type or the lock twist type, I have included both version here in 2 lengths.

Leave the spool holder you have where it is, remove the plastic nut that holds it in place and use this as the nut. Now you have 2 spool holders.

There are a few versions here:
- spools 50mm wide and 80mm wide for threaded
- spools 55mm wide for the lock twist version.


For the threaded version, I tapered the end where the rolls goes onto so you don't need supports there. It still needs a tiny bit of support where the threads are, but that's easily removed by unscrewing them. Print this Threads down with supports.

For the lock twist version, print it open side up, no supports needed. Because of that, I did not add the Ender logo, sorry.

***** I also recommend a raft for stability while printing.