Thingiverse
Ender 3 spool holder extender
von GreeFish
9
Downloads
7
Likes
0
Makes
i recommend 40-100% infill
when you have printed it, you shouldt be able to just push it in the middle of the existing holder.(just remember to remove the front nut on the holder)
Remember that it is a tight fit, so just push hard on it. if it does`t go in!
when you have printed it, you shouldt be able to just push it in the middle of the existing holder.(just remember to remove the front nut on the holder)
Remember that it is a tight fit, so just push hard on it. if it does`t go in!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!