Thingiverse
Ender 3 spool holder extension
por jipjip
1
Descargas
1
Likes
0
Makes
I have some spools that are wider than the default spool holder for the ender 3.
Most extenders I've found were meant to be screwed to the holder, which would not work for my version.
Therefor I made one that could be inserted into the original. It gives you an extra of minimal 2.5 cm.
I forgot to adjust my infill settings, so it accidentally printed with 0% infill. Works fine.
Support Overhang Angle was set to 70, so there was just enough support to get the smaller part of the piece of the floor. Less may work too.
Most extenders I've found were meant to be screwed to the holder, which would not work for my version.
Therefor I made one that could be inserted into the original. It gives you an extra of minimal 2.5 cm.
I forgot to adjust my infill settings, so it accidentally printed with 0% infill. Works fine.
Support Overhang Angle was set to 70, so there was just enough support to get the smaller part of the piece of the floor. Less may work too.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
