Thingiverse

Ender 3 Twirly Control

by makmakmo

2k Downloads

956 Likes

19 Makes

Go to Model

The original control knob on the ender 3 really annoyed me. It got worse after I updated the firmware and the steps were reduced for more accuracy. At worst the factory knob began to stick! I pulled the factory knob off and accidentally discovered I could navigate the menu a lot faster using a more narrow knob.

This knob is more narrow so you can make more turns and also has a handle to continuously turn the knob with one finger. Give it a try, you might like it.

Print with no supports. Enjoy.

Orientation - Personal preference

Update: Widened the stem hole slightly. Also deepened the stem so it now sits lower.

Source

Thingiverse

What you need to print this: Beginner Low confidence

Why?

no supports

Support-free Single piece

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer