Thingiverse
Ender 3 v2 Adjustable Y endstop
door Tin0502
3
Downloads
4
Likes
0
Makes
Adjustable endstop for Y-axis Ender 3 v2 The Design I modified is https://www.thingiverse.com/thing:3463987
The changes are as follows
1. Slightly thicker at 6mm.
This was done so the stock self tappers could be reused from my ender 3 v2 they where a bit long with the thinner one.
2. Slightly thinner and shorter adjustment slider.
This was done so I can use m4 or m5 T nuts with this set up since my ender 3 v2 didn't have pre drilled holes for the switch.
3. Added 1mm indent.
This was done to fit the small solder pins hanging down on the front of my switch.
I use this on my ender 3 v2 since the original mount broke and had no adjustment
PLA should be fine for the print I would recommend PETG or ABS I went with PETG
The changes are as follows
1. Slightly thicker at 6mm.
This was done so the stock self tappers could be reused from my ender 3 v2 they where a bit long with the thinner one.
2. Slightly thinner and shorter adjustment slider.
This was done so I can use m4 or m5 T nuts with this set up since my ender 3 v2 didn't have pre drilled holes for the switch.
3. Added 1mm indent.
This was done to fit the small solder pins hanging down on the front of my switch.
I use this on my ender 3 v2 since the original mount broke and had no adjustment
PLA should be fine for the print I would recommend PETG or ABS I went with PETG
Tin0502 publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
