Ender 3 v2 auto power off switch

i made this fit my Aquila v2 by making the arm longer. when i put it on my ender again the arm was to short and it wouldn't work. i stretched the arm out some and it works great. ialso copied my Gcode. its

G91 ;Relative positioning
G1 E-2 F2700 ;Retract a bit
G1 E-2 Z0.2 F2400 ;Retract and raise Z
G1 X5 Y5 F3000 ;Wipe out
G1 Z10 ;Raise Z more
G90 ;Absolute positioning

M106 S0 ;Turn-off fan
M104 S0 ;Turn-off hotend
M140 S0 ;Turn-off bed

G28 X Y ;home X and Y



that will slide your hot end over then your tray will slide back and bump the lever that bumps the off switch. i didn't use the original g code in the make because i wanted everything to shut down just like it normally does.

i had a problem with my power wires covering my power switch. so i made another bracket to hold the wires out of the way.