Ender 3 V2 BL Touch mount

Compact BL Touch mount for the Ender 3 V2

Initial version (my preference, unless you use the Creality firmware and don't want to update the offset):

Offset X = -39, Y = -7

Version with correct offset for Creality firmware:

Offset X = -45, Y = -20

There are two ways to set the X and Y offset:

Add M851 X-39 Y-7 to your start G code
Use Pronterface to execute the exact same command, followed by M500 so that the new offset is stored in the Eprom

The mount is fixed to the Hot End carrier by 2 M3 x 6 screws in existing holes. I had only M3 x 10 avaiable, which also works but is the maximum length you can use