Ender 3/V2 Cable Guide (Direct Drive)

This is a cable guide to route the cables from the back of the printer to the hotend in front of the X-axis. A lot of direct-drive mods require you to route the cables that way, or at least will benefit from it.

You'll need at least one zip tie, with a maximum width of 2.5 mm and a maximum thickness of 1 mm, there are holes for two zip ties.

This model prints easy and fast and doesn't require any supports. It will fit on an **Ender 3 V2** and possibly on an Ender 3 too.

**Update V2:**
- increased spacing between guide rails
- increased size of the zip tie holes
- shortened guide rails extrusion