Thingiverse
Ender 3 V2 control knob / dial
1
Downloads
3
Likes
0
Makes
i dont like the factory dial for the Ender 3 so i made this larger one with finger holes for faster/easier scrolling.
this knob is 5/8' tall and 2.5" wide at the face. it is not press fit tight. it is able to slide off if you decide to remove it.
this knob is 5/8' tall and 2.5" wide at the face. it is not press fit tight. it is able to slide off if you decide to remove it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
