Thingiverse
Ender 3 V2 Dial Indicator Holder
by Dalma1950
267
Downloads
168
Likes
2
Makes
I'm sharing my own Dial Indicator extruder mount for the Creality Ender 3 V2. It should work for most common Dial Indicators. You can place the Dial Indicator at various heights and then tighten it securely in place. Because the mount allows height adjustability you may match the dead bottom of your Dial Indicator to match the nozzle height if you wish. The Dial Indicator needle is placed precisely in front of the Nozzle (Y axis).
The Dial Indicator mount can be used along with the BL Touch mounted on the extruder. My approach to designing this was to make the indicator holder simple to put on and remove from the extruder, it simply slides on and off the extruder. (I added a small 0.1mm offset on the inside surfaces of the mount, so it can easily be placed on the extruder., however, depending on your print settings, extrusion multiplier etc. if there is a bit of play you can simply add a layer of masking tape on the inside of the holder to ensure a tight fit.)
In order to secure
The Dial Indicator mount can be used along with the BL Touch mounted on the extruder. My approach to designing this was to make the indicator holder simple to put on and remove from the extruder, it simply slides on and off the extruder. (I added a small 0.1mm offset on the inside surfaces of the mount, so it can easily be placed on the extruder., however, depending on your print settings, extrusion multiplier etc. if there is a bit of play you can simply add a layer of masking tape on the inside of the holder to ensure a tight fit.)
In order to secure
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
