Thingiverse
Ender 3 V2 Drawer replacing electronics
von spmk
28
Downloads
14
Likes
0
Makes
Since I built an enclosure for my Ender 3 V2 and had some space in the frame I made this drawer to store some more stuff and make the printer look a bit more clean. I didn't do a Knob yet, I was hoping to find one here.
So this drawer is for the left side of the printer where normally the electronics are located.
So this drawer is for the left side of the printer where normally the electronics are located.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
