Thingiverse
Ender 3 V2 Enclosure box electronics external case
door GalvanicGlaze
1.7k
Downloads
994
Likes
20
Makes
Ender 3 V2 enclosure
If you plan to make this, I don't take any liability if you hurt yourself, working with on open power supply can be deadly. If you are uncomfortable with the PSU open, keep the lid on and install it and see if it can still cool the PSU will most likely still work.
- If you are printing this on an ender 3 V2 you need to have a custom firmware installed so that you can use the full bed size. 233mm is the longest panel. Stock firmware will only go up to 220mm. This is the guide that I followed to install a custom firmware.
https://www.youtube.com/watch?v=y87P7K5DTMU&ab_channel=ruiraptor
- I have added some firmware for anyone that can't get the compiling to work
FYI If you are using Octoprint, update the bed size there as well.
Please centre the glass on your bed so the print doesn't go over the edge. Home your printer and with the move command move the x axis to 0 and check if it’s close to the edge and then move x to 235 and see if the nozzle is at th
If you plan to make this, I don't take any liability if you hurt yourself, working with on open power supply can be deadly. If you are uncomfortable with the PSU open, keep the lid on and install it and see if it can still cool the PSU will most likely still work.
- If you are printing this on an ender 3 V2 you need to have a custom firmware installed so that you can use the full bed size. 233mm is the longest panel. Stock firmware will only go up to 220mm. This is the guide that I followed to install a custom firmware.
https://www.youtube.com/watch?v=y87P7K5DTMU&ab_channel=ruiraptor
- I have added some firmware for anyone that can't get the compiling to work
FYI If you are using Octoprint, update the bed size there as well.
Please centre the glass on your bed so the print doesn't go over the edge. Home your printer and with the move command move the x axis to 0 and check if it’s close to the edge and then move x to 235 and see if the nozzle is at th
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
