Ender 3 V2 Filament Sensor Adapter

I upgraded my Ender 3 V2 with a Micro Swiss Bowden Extruder recently. I also had the Filament Sensor Kit from Creality installed. Then I noticed, that the intake of the new Extruder and the outtake of the filament sensor does not match. Therefore I designed an adapter where I only need to use the screws of the filament sensor without anything else to make it work again.
I also noticed that with the new Extruder, the option to keep the cables out of the way is also gone. I solved that by adding a little slot into the adapter that allows me to hold the cables out of the way with a small cable tie.

**ATTENTION:** be aware that you will need to cut the intake tube of the Micro Swiss Bowden Extruder a bit shorter, otherwise it gets in the way with the filament sensor during installation!