Ender 3 V2 Lead Screw Support

Ender 3 V2 lead screw support to move the support onto the vertical 2040 bar from the top 2020 bar.

I needed this part as part of a dual z-axis belt tensioner system to accomodate a GT2 pulley, but will work for general lead screw stablization too. It will eat into the available z-height of the printer, but not significantly.

The bearing mount is slotted slightly to allow for slight movement in the lead screw.

Print with support for the recessed holes on the underside for the M3 nuts.

Required hardware:

* 1x - 16mm x 8mm x 5mm Bearing
* 2x - M3 x 20mm Cap Head Bolt
* 2x - M3 Nut
* 2x - M4 x 20mm Cap Head Bolt
* 2x - M4 T-Slot Nut