Thingiverse
Ender 3 v2 LED Light Bar
von marmni
49
Downloads
29
Likes
0
Makes
LED Light Bar for Ender 3 v2 (fits to the V-Slot 2020 profile)
BOM:
- 2x M3x12 (it is best to use hexagon socket head cap screw)
- 2x M3x8 (hexagon socket head cap screw) + hammer nuts
- 2x M3 nut
- 2 wire cable
- LED strip 24V (15-20cm) - in my case it is 24V 12W/1m -> 15cm
- LED aluminum profile (15-20cm) 16x9.3 (HxD) - in my case it is 15cm
- mini ON-OFF rocker switch (or something similar)
- 2x fork connector for M4 (if you connect to the power supply)
Basic electrical knowledge is required. Incorrect connection may damage the printer/power supply.
BOM:
- 2x M3x12 (it is best to use hexagon socket head cap screw)
- 2x M3x8 (hexagon socket head cap screw) + hammer nuts
- 2x M3 nut
- 2 wire cable
- LED strip 24V (15-20cm) - in my case it is 24V 12W/1m -> 15cm
- LED aluminum profile (15-20cm) 16x9.3 (HxD) - in my case it is 15cm
- mini ON-OFF rocker switch (or something similar)
- 2x fork connector for M4 (if you connect to the power supply)
Basic electrical knowledge is required. Incorrect connection may damage the printer/power supply.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
