Ender 3 V2 X Axis Cable Holder

Simple holder for your hotend wire harness using direct drive. Routing your wires in front of the Z-extrusions will give you more Z clearence since there are no wires getting squashed betweend the x-gantry and the top extrution.

The part pushes onto the Z carrier with a bit of force. The cables are secured with zip-ties.

This mod is intended to be used with a direct drive but can be used with a bowden setup if routed correctly.

Tested on an Ender 3 V2, might work with Ender 3/Pro as well but i cannot test this.

I used support, its only the part that secures the cables with zipties that might need support.