Thingiverse
Ender 3V2 Unitak Direct Drive wire guide
di mtbmike777
5
Download
5
Likes
0
Makes
Ender 3V2 Unitak Direct Drive wire guide
No amount of zip ties and trying have I ever managed to get all the wires in a place that didnt either catch on the frame when calibrating before a print or when bed levelling, or if i did it looked an eye sore.
Im not going to lie to you and say this is easy to fit because it aint if you have a fully assembled hot end.
the way ive done it is 2x10mm M3 bolts pinched with tweezers and inserted from belowand into the 2 spare holes you have on the DD mount you have. then the guide placed over the 2 bolts, tweezers to push the bolts up and secured with a nut! took me a cple of attempts and 1 lost nut!
but its on and now i finally have fixed wires that are tidy and not in the way of anything only taken 3 years to do it!
mines in CF PETG
237'c
80'c
45mm
.5 noz
.3 layer
20% infill Gyroid
35 min print
No amount of zip ties and trying have I ever managed to get all the wires in a place that didnt either catch on the frame when calibrating before a print or when bed levelling, or if i did it looked an eye sore.
Im not going to lie to you and say this is easy to fit because it aint if you have a fully assembled hot end.
the way ive done it is 2x10mm M3 bolts pinched with tweezers and inserted from belowand into the 2 spare holes you have on the DD mount you have. then the guide placed over the 2 bolts, tweezers to push the bolts up and secured with a nut! took me a cple of attempts and 1 lost nut!
but its on and now i finally have fixed wires that are tidy and not in the way of anything only taken 3 years to do it!
mines in CF PETG
237'c
80'c
45mm
.5 noz
.3 layer
20% infill Gyroid
35 min print
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!