Ender 3V3 Plus Filament Relocation System

Those who have the Ender3v3 plus know the filament location is garbage. I've seen a few takes on solving this and here's mine. It's fairly complicated and involves drilling and tapping into your machine so it's not for everyone. I am also not gonna put all the exact dimensions and everything mainly because I don't remember and don't wanna go back and measure. But if there enough interest I will come back and update everything.

First relocating the spool holder, if you look at the top bar on the right side; you will notice there are 2 little thickened pads of metal. Those are for the spool holder, it's like they had a good idea and decided not to do it. I measured the spacing of the original hardware copied it to the upper bar, made sure it lined up, then drilled and tapped it. Now the factory spool holder fits on the factory spool holder hardware. Good. Great. Moving on.

Relocating the filament runout sensor, look...to be honest while I was de