Thingiverse
Ender 4 PSU Switch
von donminca
11
Downloads
10
Likes
0
Makes
wandering about thingiverse I did not find anything that could fit me for the space I have available and so I invented this little box.
I used all the recycling stuff, I had an old power supply for broken pc and I took the plug and switch (from the power supply I also took the filter, but only because I found them in), so if you buy them these are the specific names:
- IEC 320 C14 (male connector)
- 6A 250V switch (because the 3A one is slightly smaller in size)
I ran the cables behind the power supply plate in the 4020 slot.
To screw it I used 2x M4 x 10 with t-nuts always found here on the site.
I used all the recycling stuff, I had an old power supply for broken pc and I took the plug and switch (from the power supply I also took the filter, but only because I found them in), so if you buy them these are the specific names:
- IEC 320 C14 (male connector)
- 6A 250V switch (because the 3A one is slightly smaller in size)
I ran the cables behind the power supply plate in the 4020 slot.
To screw it I used 2x M4 x 10 with t-nuts always found here on the site.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
