Ender-4 Y carriage

**NOTICE** A remix based on this might be better suited for you, i like it better: https://www.thingiverse.com/thing:2699155

Slightly more skookum replacement Y Carriage for Creality Ender-4. Has an 2020 X-axis bar guide on bottom with basicly 0 tolerance fit to really ensure it remains straight and removes, atleast helps to, remove the typical H-Bot rotational torque wobble.

It has tight fit, and then some with basicly crush fitting, so really tighten well those T-nuts, this takes **all** play from it away. Infact when assembling the X axis went directly to straight by accident, i kinda even forgot i need to check for that.

I also made the wheel bearing distance 0.5mm tighter than supposed to be extra certain, so assemble with eccentric nuts all the way out. I used a pen to mark which side is furthest away.
Also check your eccentric nuts, many of what creality supplies is not very eccentric at all.

This is based on the original measurements then small changes.

Two vers