Ender 5 Adjustable Bed Support Struts

Remix of the excellent struts made by NykC .
This is a bolt together version.
The lever design NykC used is excellent, but I made this as an alternative.

The clamp design allows for some vertical adjustment.
This design also features a thicker top edge on the cross bar.

There is only one clamp set provided.

In Cura duplicate the clamp set then mirror the duplicate so you get the left and right clamp sets.

The cross bar should be printed with supports (bed only). The two thinnest edges should be placed on the bed plate with the holes for the rods facing upwards.




To complete this you will need :


2x M4 (4mm) threaded rods

4x M4 (4mm) Washers.

4x M4 (4mm) hex nuts and the bolts to fit. The bolts should be 20mm