Ender 5 BLTouch Mount

I struggled to find good Ender 5 BLTouch Mount.

So i took the best one I found and made some modifications to it to make it stiffer and more secure. You use the two shroud screws and the top left wheel screw to hold it in place.

I printed it in ABS but PLA would do the job perfectly, as it has even better layer adhesion than ABS sometimes. Just use more walls or a bigger infill to make it solid !

You will need :
-2x M3X12 screws
-2x M3 Bolts (nylock are better), to hold the BLTouch / 3DTouch in place
-1x M5 washer, for the wheel hole

-Offsets here (not exact but does the job perfectly) :
X : -38
Y : -16

Tell me if there are any issues with the file, for slicing or using it.
If you have any improvements ideas, just tell me in the coments section !