Thingiverse
Ender 5 BLTouch Mount
by sjaak31367
0
Downloads
0
Likes
0
Makes
Description:
The light of the BLTouch made my timelapse camera underexpose, so I designed a cover for the BLTouch probe on my Creality Ender 5 Plus (might work on other Ender 5's too, unsure).
Beware you might need to change the probe/bed Z-offset (`M851 Z`) after installing this
(for me it's at `M851 Z-2.95` (and either save to EEPROM (`M500`), or put it in your starting g-code.))
Note: I made this back in 2021, but never hit publish until 2024, so not sure how useful this still is, but if you have an Ender 5 (Plus) and are tire of the BLTouch's brightness, it might still be of use! :3
Hardware required:
2x M3 nut
2x M3 bolt (flat bottom, 12+mm)
Print settings:
cover: 40% Gyroid infill
The light of the BLTouch made my timelapse camera underexpose, so I designed a cover for the BLTouch probe on my Creality Ender 5 Plus (might work on other Ender 5's too, unsure).
Beware you might need to change the probe/bed Z-offset (`M851 Z`) after installing this
(for me it's at `M851 Z-2.95` (and either save to EEPROM (`M500`), or put it in your starting g-code.))
Note: I made this back in 2021, but never hit publish until 2024, so not sure how useful this still is, but if you have an Ender 5 (Plus) and are tire of the BLTouch's brightness, it might still be of use! :3
Hardware required:
2x M3 nut
2x M3 bolt (flat bottom, 12+mm)
Print settings:
cover: 40% Gyroid infill
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
