Thingiverse
Ender 5 bottom holder positioner
von BTA_Garage
1
Downloads
0
Likes
0
Makes
Ever had a problem when printer moved and you had layer shift because it crashed in enclosure or a wall? I DID!
It was a pain to figure what went wrong.
So designed this holder to screw on your enclosure or table top.
Just use standard wooden screws 3mm diameter. I used 2x12mm wood screws.
See where your printer must be and screw them down and never worry about a walking printer again!
It was a pain to figure what went wrong.
So designed this holder to screw on your enclosure or table top.
Just use standard wooden screws 3mm diameter. I used 2x12mm wood screws.
See where your printer must be and screw them down and never worry about a walking printer again!
BTA_Garage veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
