Thingiverse
Ender-5 Control Panel Back Cover SLIM
von MRSW3D
55
Downloads
18
Likes
3
Makes
My remix of the Ender 5 contol panel back cover
I liked the design, but after a print I thought it felt a bit unnecessary bulky, so I took measurements of the printed part and made a new one from scratch and made it a bit thinner and also with vents.
Both to save some filament and to let more air pass (if it even needs to, fells pretty at least imo)
Also made it a few MM deeper to leave som space for the parts inside, the original was a bit too snug for my opinion.
I liked the design, but after a print I thought it felt a bit unnecessary bulky, so I took measurements of the printed part and made a new one from scratch and made it a bit thinner and also with vents.
Both to save some filament and to let more air pass (if it even needs to, fells pretty at least imo)
Also made it a few MM deeper to leave som space for the parts inside, the original was a bit too snug for my opinion.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
