Ender 5 Dual Z - Version 2

--- Update 6-10-2020 ---
Added Ender 5 Dual Z - Rod Bracket - Upper v2 - Adjustable v6.stl. This can be used for the upper rod mount. My frame was not square so the distance from the rods was greater at the top and was causing binding. This adjustable bracket was used to keep the rod-to-rod spacing the same. This can only be used on the top. Using on the bottom will throw off rod-to-leadscrew alignment.
--- Update Done ---



This is Version 2 of this mod: https://www.thingiverse.com/thing:3784970

This mod requires replacing the top left and right extrusion with 2040. This is required to allow space to mount the top rod brackets. This also gives the added benefit of raising the extruder up 20mm to be more easily viewed and to allow more Z travel. Be mindful of belt routing when mounting the rod brackets. A linear rail mod might be able to be used instead of replacing the extrusion.

Version 2 was created to allow the bed to be centered and rotated. Centering the bed