Thingiverse
Ender 5 Fan Mod - Airflow Optimization
von jsjamboree
59
Downloads
34
Likes
0
Makes
This is a remix of the updated CR-10 Fan Mod - Airflow Optimization specifically for the Ender5 and Ender5 plus.
The biggest issue with every fan mod I have tried in the past is that it doesn't align with the nozzle correctly, it generally off about 2.5mm. This lines up great with the nozzle.
The inlet was modified to fit inside the fan, the mounts were thickened to properly fit the fan on the 5 plus, and the air outlet was moved 2.5mm so that it aligns correctly with the nozzle.
This works with both a stock setup and Microswiss direct drive setup.
The biggest issue with every fan mod I have tried in the past is that it doesn't align with the nozzle correctly, it generally off about 2.5mm. This lines up great with the nozzle.
The inlet was modified to fit inside the fan, the mounts were thickened to properly fit the fan on the 5 plus, and the air outlet was moved 2.5mm so that it aligns correctly with the nozzle.
This works with both a stock setup and Microswiss direct drive setup.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
