Thingiverse
Ender 5 LED bar bracket
von looxonline
10
Downloads
6
Likes
0
Makes
Needed some more light on my Ender 5 print bed. Picked up some cheap LED bars from Banggood (https://www.banggood.com/50CM-SMD-5730-36-LED-Rigid-Strip-Tube-Bar-Light-Lamp-With-U-Aluminium-Shell-PC-Cover-DC12V-p-1088115.html?rmmds=myorder&ID=233520867&cur_warehouse=CN) and designed these brackets to mount the bars behind the gantry and at the front of the printer.
The front bar includes a PS3 Eye camera mount on the LHS bracket. To use the mount simply peel away the foam from the bottom of the PS3 eye, remove the two screws, remove the metal insert and use the same screws to secure the PS3 eye to the mount.
The rear bar is hidden from a bed level camera lens so that it does not mess with the exposure but it shines down at the print at an angle which allows for some nice light scattering.
I use it on a printer that has had the Ender 5 bed raise mod applied which will also affect where it sits relative to the gantry.
Installation:
The LHS bracket at the back uses an M3 scre
The front bar includes a PS3 Eye camera mount on the LHS bracket. To use the mount simply peel away the foam from the bottom of the PS3 eye, remove the two screws, remove the metal insert and use the same screws to secure the PS3 eye to the mount.
The rear bar is hidden from a bed level camera lens so that it does not mess with the exposure but it shines down at the print at an angle which allows for some nice light scattering.
I use it on a printer that has had the Ender 5 bed raise mod applied which will also affect where it sits relative to the gantry.
Installation:
The LHS bracket at the back uses an M3 scre
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
