Thingiverse
Ender 5 LED strip holders
von dbltrbl023
1.2k
Downloads
699
Likes
4
Makes
A pair of holders for 30cm LED strips (10mm wide)
One for the front with 10 degree angle down, and the one in the back has a 66 degree angle so it doesn´t shine straight in your face.
They are both split in two parts which snap together with some glue. (Couldn´t fit them on the printbed)
Mount with T-nuts and short M3 screws
Print the front holders with support and the back without
Edit: I noticed that my Front LED holder was getting a little bent, not being 100% straight in the joint. Therefore I made a small add-on. A third mount that fits perfectly in the center.
IF this happens to you as well, there´s no need to re-print, just add this small piece ("xtraholder.stl")
One for the front with 10 degree angle down, and the one in the back has a 66 degree angle so it doesn´t shine straight in your face.
They are both split in two parts which snap together with some glue. (Couldn´t fit them on the printbed)
Mount with T-nuts and short M3 screws
Print the front holders with support and the back without
Edit: I noticed that my Front LED holder was getting a little bent, not being 100% straight in the joint. Therefore I made a small add-on. A third mount that fits perfectly in the center.
IF this happens to you as well, there´s no need to re-print, just add this small piece ("xtraholder.stl")
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
