Ender 5 Plus Hemera Mount with BLTouch MK2

#### Mark II XS
For a request, I made an XS compatible version of the MK2 labelled MK2_XS. It's exactly the same as the MK2 version but has two additional mounting points spaced to match with the XS stepper motor mounts. Should work the same and maintain clearances.

#### Mark II
Alright, so the original version bugged me because the entire Hemera assembly sat so low on the carriage that it caused interference with the Ender 5 Plus bed guide rod mounting brackets (the four silver T-shape ones on each inside corner).

This meant that the fan duct in the original had to be configured to sit higher than optimal, and there was a risk of your BL Touch probe catching on the brackets. This meant you would suffer a reduced print area to account for a safe print space, in my case 324x340. Not major, but there must be a better way.

Mark II to the rescue!

The entire Hemera assembly has been raised several millimetres and the BL Touch has been relocated to the right side of the Hemera